Servos
Accumulator. Left to right: Accumulator
spring, accumulator piston (PN xxx)
Front Servo. Left to right: Cover (PN xxx),
outer spring, inner spring, plunger. Snap ring underneath.
Rear servo. Left to right: snap ring,
piston, small cup spring, blah cup, cup snap ring, cover.
Underneath is the old and new blah springs.
Governor
Governor body and parking gear
Governor pieces. Parking gear at top.
Next, left to right: blah valve, rod and E-clip, blah weight, spring, weight,
inner and outer snap rings, E-clip
Gears and Such
Output shaft, governor snap ring, planetary snap
ring
Front drum
Front clutch piston
Front clutch disk
Rear clutch pack.
At the top, left to right (under the output shaft): rear clutch
retainer, spring, blah retainer and input shaft
Underneath, left to right: clutch spring snap ring, blah
pressure plate, clutch disk, steel disk, etc, blah pressure
plate, pressure plate snap ring.
Rear clutch piston
Rear clutch disk
Front annulus gear, front planetary gear set,
and their thrust washer.
Driving shell, snap rings and thrust washer
Rear annulus and planetary gears
Rear drum and overunning clutch
Overunning clutch
Bands and Linkages
Fuzzy picture of the front band lever, pivot,
and pivot plug
Rear band linkage. blah lever, blah lever,
pivot and blah lever. Not shown is the small blah lever
Rear band. It's the dark, circular part. You can see its grooves near the bottom of the picture.
Case
Case (big block PN 2400066)
Neutral safety switch
Output yoke, washer and nut
Transmission oil pan
Park mechanism. On the left is the apply
lever, spacer, pivot and needle bearings. On the right is the sprag
pivot, finger and spring.
Output shaft bearing and its snap ring
Pumps
Front pump outer housing
Front pump rotors
Reaction shaft, reaction shaft support and
spacer washer
Rear pump housing
Rear blah blah
Rear pump outer and inner rotors
Valve Body
Transfer plate (PN xxx) and Steel plate
Rear pump check valve and spring
Reverse blocker valve, spring, cover
plate and screws
Valve body and valves.
On the left from top to bottom: 2 to 3 shift valve and spring;
1 to 2 shift valve and spring; blah, blah and blah
The valve body casting is in the center (PN xxx)
On the right from top to bottom: 2 to 3 shift plug;
shuttle valve, spring and plug; 1 to 2 shift plug;
manual valve; throttle valve, spring, blah and blah;
throttle valve adjuster; line pressure regulator valve and spring;
torque convertor valve and spring
Valve body unit
Miscelaneous
The spider that hung around while I was working
All the major assemblies.
On the top row, left to right: rear drum and planetary, driving
shell and sun gear, front band, rear band
Next row: Rear clutch pack, retainer and input shaft, front drum
and clutch pack, tailshaft housing
The front annulus gear is at the bottom, and the main case is
on the far right
Another view of the major internal assemblies
On the left: the rear drum, rear planetary and annulus gears.
underneath that is the front drum and its clutch disks
In the center: the driving shell and sun gear are in the
very back, in front of that is the blah retainer and input
shaft, blah retainer, and the stack of rear clutch disks
On the right is the front annulus gear in the back, front
planetary gears in front of it, and the reaction shaft and
support sitting on top of the front pump cover.